1.You can contact the customer service. for any question regarding the product.
2.Ask the question in English to get answer faster.
3.Keep your question short and to the point.
Oñemo'ã porãva
Name | Attributes | Function |
CSN2500 | Input | CC2500 chip select signal |
CSN2401 | Input | NRF24L01 chip select signal |
CSN7105 | Input | A7105 chip select signal |
CSN6936 | Input | CYRF6936 chip select signal |
SCK | Input | SPI Interface clock signal |
MOSI | Input | SPI Interface input from the device |
MISO | Output | SPI Interface output from the device |
VIN | Power Source | 4.5V-8V Input |
GND | Power Source | Ground |
RST6936 | Input | CYRF6936 chip select signal |
A part of the review has been auto-translated.
Installed this in my Devo 7e so I could control my other quads, Syma X5, X11, Eachine QX95, H8 and E010. Fairly easy to install if you follow the guide here http://www.deviationtx.com/forum/how-to/5955-7e-ultimate7e-adding-the-devo-version-4in1?limitstart=0
Works great!
Add a couple of 3 position switches and I can control anything with it now :)
Hi,
As I personally experience hard time to find all information necessary to get it work on my Devo 6. Probably because Devo 6 users are not legions… I write down here all information and steps to install it. Hope that it may help someone.
Step 1 :
Open the Devo 6 by the back, taking of the rubbers, screws are just behind.
Step 2 :
Take of the original transmitter cheap (really looks like the new one). And it is just plugged in main board. Take of the antenna, and put it on your new 4in1 module.
Step 3 :
Solder the 3 wires like on pictures.
4in1 Module - Devo6 Mainboard
----------------------------------------------
CSN2401 -> C10 (left on P19)
CSN2500 -> TCK
CSN7105 -> TMS
Step 4 :
Place back the 4in1 module in original plug.
Step 5 :
Close you devo.
Step 6 :
Enable the use of 4in1 module in Deviation (I use version 5.0.0) (Off course you already install Deviation instead of Walkera original Devention Software. If not, please first go to deviationtx.com). So connect your devo to USB port, power it USB mode (Press ENT key while switch on). Open Harware.ini and configure it like that :
;Only useful for transmitters with an after-market vibration motor
;enable-haptic=1
;
;switch_types: 3x2, 3x1, 2x2
;extra-switches=
;
[modules]
; there is no need to enable the cyrf6936 module unless
; it is wired to an alternate port. It is Enabled automatically otherwise
enable-cyrf6936 = B12
has_pa-cyrf6936 = 1
enable-a7105 = A13
has_pa-a7105 = 1
enable-cc2500 = A14
has_pa-cc2500 = 1
enable-nrf24l01 = C10
has_pa-nrf24l01 = 1
; enable-multimod = A13
Reboot your Devo 6 and that’s all to enjoy.
Rgds
Pascal.
Tips:For questions about your order, place of delivery, product discount, taxation, delivery time, warranty, shipping, payment, exchange rate, and other questions unrelated to the product, please contact customer service.
A part of the QA has been auto-translated.